in vehicle computer, car computer,in cab computer, bus pc, can bus, e-凯时app下载

         
网站导览  global / 簡体中文   [ language ]
 
  凯时人生就是博下载首页 > 解决方桉 > 车载电脑 > 凯时人生就是博下载的解决方案
 
凯时人生就是博下载的解决方案
the in-vehicle computer power subsystem challenges
发表日期: 2011/05/10
 
 

the challenging electrical and environment conditions found in modern automobile have a strong impact on the design of automotive power electronic equipment. important factors affecting the design of electronics for this application include static and transient voltage ranges, electromagnetic interference and compatibility requirements (emi/emc).
the transients on the automobile power supply range form the severe, high energy, transients generated by the alternator/regulator system to the low-level ’’noise’’ generated by the ignition system and various accessories. a standard automotive electrical system has all of these elements necessary to generate undesirable transients.

typical automotive transients

typical automotive transients

the society of automotive engineers (sae) has defined the automotive power supply transients which are present in the system. table 1 shows some sources, amplitudes, polarity, and energy levels of the generated transients found in the automotive electrical system(1).

table 1. typecal automotive transients

 

 length of  

 transient

            

              cause

energy capability

 

    frequency of  

     occurrence

voltage amplitude

steady state

failed voltage regulator

                         

infrequent

18v

 

5 minutes

jump start with 24v battery infrequent

                   

infrequent

/-24v

200ms to 400ms

load dump; disconnection of battery while at high charging

<10j

infrequent

<125v

<320 us

inductive-load switching transient

<1j

often

300v to 80v

200ms

alternator field decay

<1j

each turn-off

-100v to -40v

90ms

ignition pulse, battery disconnected

<0.5j

<500hz several times in vehicle life

<75v

1ms

mutual coupling in harness

<1j

often

<200v

15us

ignition pulse, normal

<0.001j

<500hz continuous

3v

burst

accessory noise

<1.5v

50hz to 10khz

burst

transceiver feedback

~ 20mv

r.f.

<50ns

esd

<10mj

infrequent/ random

15kv

 

with the extensive use of computer in today’s vehicles, protection from transient over voltages is essential to ensure reliable operation.

acrosser solution

all acrosser’s power subsystem is designed with protections to prevent damage from most of the transient over voltage in vehicles.
1. automotive transient voltage suppression
2. over voltage and under voltage protection
3. over current protection
4. reverse voltage protection
5. automotive fuse

acrosser ensure its perform as designed during and after exposure to disturbance by certified with the e-mark.
e/e-mark is the economic commission of europe (ece) that grants certificates to ensure all automobiles equipments sold by manufacturers meet traffic safety and environmental protection requirements.
the e-mark certification includes a series of vehicle transient voltage test according to the iso 7637-2. iso 7637-2 was prepared by technical committee iso/tc 22, road vehicles. it defined specifies bench tests for testing the compatibility to conducted electrical transients of equipment installed on passenger cars and light commercial vehicles fitted with a 12 v electrical system or commercial vehicles fitted with a 24 v electrical system — for both injection and the measurement of transients. there are 8 types of test pulse defined to simulate different transient voltage in real vehicle environments. table 2 shows the test pulses defined in iso 7637-2.

 test pulse

                                                simulation

 

        1

this test is a simulation of transients due to supply disconnection from inductive loads. it is applicable to duts which, as used in the vehicle, remain connected directly in parallel with an inductive load.                              

 

       2a

pulse 2a simulates transients due to sudden interruption of currents in a device connected in parallel with the dut due to the inductance of the wiring harness.

  

       2b

pulse 2b simulates transients from d.c. motors acting as generators after the ignition is switched off.

 

    3a & 3b

these test pulses are a simulation of transients which occur as a result of the switching processes. the characteristics of these transients are influenced by distributed capacitance and inductance of the wiring harness.

    

        4

this pulse simulates supply voltage reduction caused by energizing the starter-motor circuits of internal combustion engines, excluding spikes associated with starting

 

 

      5a, 5b

this test is a simulation of load dump transient, occurring in the event of a discharged battery being disconnected while the alternator is generating charging current and with other loads remaining on the alternator circuit at this moment. load dump may occur on account of a battery being disconnected as a result of cable corrosion, poor connection or of intentional disconnection with the engine running.

 

 
 
 
车载电脑
  凯时人生就是博下载的解决方案
  solution stories
  相关产品
工业自动控制应用
游戏机、赌博机、乐透彩机应用
销售端点系统/数字标牌/自动柜员机
串列设备连网伺服器
医疗
网络计算(网络安全和网络通信)
無標題文件
aiv-hm76v0fl
无风扇车载系统中,英特尔酷睿i3/ i5的/ i7处理器 hm76智能电源系统,gps/3.5g/ wifi /蓝牙选件模块
   
ar-v6100fl
无风扇车载系统,英特尔酷睿i5/ i7处理器 hm65智能电源系统,gps/3.5g/ wifi /蓝牙选项
   
ar-v6005fl
无风扇车载系统,英特尔凌动e640智能车载电源,gps/3.5g/ wifi /蓝牙选项
   
ar-v5430fl
taiwan excellence 2010 - fanless and dustproof intel 945gme core 2 duo vehicle computer
   
ar-v6002fl
无风扇防尘英特尔凌动d425/ d525车载电脑
   
 

关于欣扬 | 产品资讯 | 凯时人生就是博下载的解决方案 | 新闻与活动 | 技术支援 | 联络我们 | 凯时人生就是博下载首页
凯时app下载 copyright © 2017 acrosser technology co.,ltd.all right reserved.